Wavetronix SmartSensor Matrix (SS-225) - User Guide Manuale Utente Scaricare il pdf (Pagina 83)

82 CHAPTER 8  ZONES & CHANNELS

placed zones are also mapped to the rst ten detection channels respectively.

Editing Zones

Click the Edit Zone button to adjust the currently selected zone. An entire zone can be

moved by clicking and dragging or by using the arrow buttons on the Edit Zone window

(see Figure 8.5). Zones can overlap each other. is window can also be used to add a delay

or extend time (in seconds) to this particular zone. When you click the Make small zone

checkbox, a narrow zone will be created, which is recommended for counting channels.

Figure 8.5 – Edit Zone Window

Placing AutoZones

Click the Place Auto Zones button if you would like to replace your manually congured

zones with auto zones. Placing auto zones requires you to insert the distance from the stop

bar and also the auto zone width (see Figure 8.6). Clicking Yes will add a zone to each au-

tomatically congured lane.

Figure 8.6 – Placing Auto Zones Prompt

If zones are too long for the SSMM view, the zones will be cropped so that the entire zone

can be seen. For more information on auto zones, see the auto zone information at the be-

ginning of this chapter.

Note

Please note that all existing zones will be removed before new zones are placed au-

tomatically.

1 2 ... 78 79 80 81 82 83 84 85 86 87 88 ... 116 117

Nessun commento

Wavetronix SmartSensor Matrix (SS-225) - User Guide Manuale Utente Pagina 83