Wavetronix SmartSensor Matrix (SS-225) - User Guide Manuale Utente Scaricare il pdf (Pagina 26)

CHAPTER 2  CABINET SOLUTIONS 25

Figure 2.6 – Preassembled Backplate Installation Basics

If you use the preassembled backplate, you’ll connect the sensor or sensors to the terminal

blocks on the bottom row of the backplate. e Click devices on the upper row will provide

surge protection and clean DC power for the devices, as well as RJ-11 jacks that you’ll con-

nect to contact closure cards in an input le rack. is rack will then send detection data

on to the controller.

Note

There are a few alternate versions of the preassembled backplate: the preassembled

19-inch rack for server racks and the intersection segmented preassembled backplate

for easier installation in trac cabinets (this device has the necessary components

spread across a few smaller backplates; these can be helpful in cabinets where space

is tight because they don’t require such a large block of space to be made available).

For more information about the preassembled backplate, see Appendix D in this guide.

Terminating SmartSensor 6-conductor Cables

Each of the cabinet solutions discussed up to this point uses the same method for terminat-

ing the 6-conductor cable coming from each sensor: they must be landed into plugs that t

the terminal blocks on the backplate and the sensor ports on the cabinet interface devices.

(see Figure 2.7 and Table 2.1).

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 116 117

Nessun commento

Wavetronix SmartSensor Matrix (SS-225) - User Guide Manuale Utente Pagina 26