Wavetronix SmartSensor Matrix (SS-225) - User Guide Manuale Utente Scaricare il pdf (Pagina 27)

26 CHAPTER 2  CABINET SOLUTIONS

Figure 2.7 – Color Label on Plug-in Terminals

Each 6-conductor cable has one DC power wire pair, two RS-485 communication pairs,

and a drain wire (see the above gure). Follow the steps below to land the sensor cables into

the plugs.

1 Aer routing your SmartSensor 6-conductor cable into the cabinet, carefully strip back

the cable jacket and shielding on the service end of the cable.

2 Open the insulation displacement connectors on the plug by inserting a small screw-

driver into each square slot and rocking it back.

3 Insert the wire leads into the bottom side of the plug-in terminal according to the color

code shown in Table 2.1 and Figure 2.7. Make sure the wires are completely inserted

in the terminal.

4 Close the insulation displacement connector by reinserting the screwdriver into the

square slot and rocking it forward. e plug-in terminals will automatically complete

the electrical connection. ere is no need to manually strip the insulation on the end

of each wire.

Do not strip the service end of the cable until aer it has been routed through conduit. e

cable should be one continuous run without any splices.

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 116 117

Nessun commento

Wavetronix SmartSensor Matrix (SS-225) - User Guide Manuale Utente Pagina 27