Wavetronix SMARTSENSOR 105 Guida Utente Scaricare il pdf (Pagina 68)

CHAPTER 6  SENSOR SETTINGS 67

to quickly change transmission direction. e default value is 10 milliseconds. is

value can be selected for both of the sensor’s ports independently.

Note

In many cases, SSMM will be connected over port 1. A green arrow is used to show

the port over which SSMM is connected to the sensor. During troubleshooting or

other special cases, you may want to connect to the sensor over port 2. Port 2 is

connected to the orange RS-485 wire pair and is typically used for detection calls.

 Data Push – Data can be pushed over port 1, port 2 or both. To disable data push,

select None. In many cases, data push will only occur over port 2.

If you would like to change which port is used to push data, please contact Wavetronix

Technical Services rst, as changing this setting can aect how the sensor, and other

devices connected to it, are wired.

Note

If for some reason SSMM connects over the same port that SmartSensor Matrix

is using to push data, the software will continue to poll the sensor for detection

call messages. This will help keep the intersection operating normally during the

conﬁguration process.

 Source – In normal use, the source is always the radar antenna. However, in some

cases, other sources may be used for demonstrations or evaluations. When the source

is switched to Diagnostic, the antenna is no longer used. Instead, a predetermined

sequence of trac will appear.

Sensor Info Screen

Some of the Sensor Settings information can be viewed on the Sensor Info screen. After

searching for sensors, select a sensor from the list and either click on the sensor icon in the

upper right corner of the Communication screen or click again on the sensor row and the

Sensor Info screen will appear (see Figure 6.3).

1 2 ... 63 64 65 66 67 68 69 70 71 72 73 ... 106 107

Nessun commento

Wavetronix SMARTSENSOR 105 Guida Utente Pagina 68