Wavetronix SMARTSENSOR 105 Guida Utente Scaricare il pdf (Pagina 54)

CHAPTER 5  COMMUNICATION 53

Figure 5.3 – Firmware Versions (left) and Hardware Versions (right)

If you are using SSMM on a computer, you can use the panel in the lower left of the main

screen to change the size of the user interface on your computer. Click any of the three

squares to increase or decrease the size of the user interface.

e rst step is to make a connection to the sensor. e following three types of connec-

tions can be made:

 Serial connection – Made using Bluetooth, RS-232, or RS-485 communication.

 Internet connection – Made using an IP address and a serial to Ethernet converter.

 Virtual connection – Made for convenience in learning and demonstrating SSMM

functionality.

Communication settings are stored in the system registry each time a connection is estab-

lished. After the rst connection is made to the SS225, the SSMM software will save the

connection settings that were used. Click the magnifying glass icon on the right side of

the communication link to connect using the most recently used parameters stored in the

registry.

Serial Connection

1 Click on Communication to access the Communication window (see Figure 5.2).

2 Select the Serial tab.

3 Set Port and Timeout to the desired settings.

4 Select the type of search (Full or Quick) you would like to perform. A full search will

nd all SmartSensor Matrix units on the selected RS-485 control bus and can take

up to 30 seconds; a quick search can be used after the rst time a full search has been

performed.

1 2 ... 49 50 51 52 53 54 55 56 57 58 59 ... 106 107

Nessun commento

Wavetronix SMARTSENSOR 105 Guida Utente Pagina 54